43
Trendline 3
or:
·
Right-click on the element, keep the mouse button pressed, and drag the
element onto the target element. A pop-up menu displays.
·
Select
Move
.
3.4.2 Automatic assignment of RFID tags to measuring points
In order to simplify allocation of measuring points in the Trendline configuration to
measuring point in your system, you can add RFID tags to them. The Detector can
read existing RFID tags at the measuring points and automatically assign the
measured values to the correct measuring point in the Trendline software.
If you transfer a configuration with RFID settings to a Detector
without an RFID reader, it displays an error after data transfer and
ignores the RFID settings.
Assigning an RFID tag to a measuring point
Before using, you must assign the RFID tags placed on the measuring points. You
can do this immediately before a CM or balancing measurement. Select the
measuring points wither in the Trendline software or in the on-site Detector:
Selection in the Trendline software
1. Select a measuring point in the Trendline configuration.
2. Click on the
Configuration
tab.
3. In the
RFID Status
box select
Assign RFID
.
4. Repeat this procedure for all measuring points to which you wish to assign RFID
tags.
5. Send
the configuration to the Detector.
6. During the round, select the appropriate measuring point in the Detector (see
Selection of measuring point
).
a) Select
Start measurement
. The Detector reads the RFID tag on site and
assigns it to the measuring point.
b) If you do not want to perform a measurement but just want to assign the RFID
tag, select
Assign RFID
at the appropriate measuring point on the Detector.
7. Load the data from the Detector in Trendline. The RFID status of the measuring
points is now set to "RFID assigned" and the green RFID icon is displayed in
front of the measuring point in the configuration tree.
67
183
