227
Detector III
In the "Alarm" line, an alarm status overview of all characteristic values is
displayed. A scrollbar is displayed on the right of the display if more than one
characteristic value exists. Characteristic values with exceeded main alarm limits
are highlighted.
In the following table the used icons are explained:
Symbol
Meaning
This characteristic v alue is OK.
No alarm occurred.
For this characteristic v alue the pre-alarm threshold has ex ceeded.
A pre-alarm occurred.
For this characteristic v alue the main alarm threshold has ex ceeded.
A main alarm occurred.
For this characteristic v alue the alarm status could not be assessed
(e.g. because of canceling the temperature measurement).
Press the time signal button
to switch to the Time signals or Trend display
. In the time signal display you can switch to the FFT display
.
In the Detector, you now have the possibility to add a measurement comment:
Press the Function button .
In the comment list, you can create a new comment or select an existing one
(see "Managing comments for measurements
"). If no comments exist in
the list, the edit field for the comment input is shown. To change comments
with the Detector key pad proceed as follows:
You can move the cursor into the required position using the cursor keys
and
. You can set the the upper or lower case for each position by using the keys
and
. Additionally, you can open a character map in the edit field with the
function button . You can enter max. 49 characters, which are shown on the
229
230
68
