50
3. Close the Device manager.
Removing the adapter software
The adapter software can be removed as follows:
1. Go to
Start
,
Control panel
and then click on
Software
.
2. Click on
Modify or remove program
then click on
PL-2303-USB-to-Serial
.
3. Click on
Uninstall/Change
to uninstall the software.
4.3.3 Balancing activation
The Detector III is supplied ex works with the balancing function deactivated. You
can enable this function if you have purchased a Detector III balancing kit.
The balancing kit contains a USB dongle that can be used to enable one unit
only.
Dongle
This activation is basically carried out as follows:
A dongle that has not previously been used is supplied with the balancing kit.
You can use this dongle to enable the balancing functionality for only one (any)
Detector.
Once enabled, the serial number of the Detector is saved on the dongle. From
this point onwards the dongle may only be used with this specific Detector.
You can also deactivate the balancing functionality in the Detector, again using
the corresponding dongle. The serial number on the dongle is then deleted
and you can now use it to enable any other Detector of your choice. This is
useful, for example, if you are sending a Detector to the manufacturer for
