9
General
Balancing with the Detector III (available as accessory function)
There are many and diverse reasons for unscheduled machine standstills.
However, a considerable number of these is due, directly or indirectly, to
imbalance or alignment errors. During operation, imbalance may cause severe
vibrations that can lead to consequential damage, for example premature bearing
wear or fatigue-induced breaks. The result is machine failure and thus
unscheduled production downtime.
The FAG Detector III is a tool with which you cannot only detect but also remedy
such conditions easily and efficiently. The easy user interface provides good
support during the balancing process. Step by step, the device software guides
the user through the balancing process. The user can create a configuration for
each balancing process with the Trendline software. Furthermore, he can define
templates that can be adapted on site on the machine. The balancing results are
sent to the Trendline software. You can display them there in table form or as a
diagram.
Analyzing data with the Trendline bearing database
The integrated bearing database (approx. 20,000 bearings from various
manufacturers) simplifies and speeds up analysis of measured data in
combination with the FIS Viewer. It allows you to detect any irregularities at first
glance and assign the appropriate components. You can save multiple bearings
per measuring point. This allows you to check multiple bearing ball-pass
frequencies at a measuring point. Every user can add new entries to the bearing
database to suit individual needs.
