22
When using Switch ID Pairing only one sensor node is paired to the wall switch but the sensor node will still distribute the
message via IR. There’s no need to assign the wall switch to a zone, as it is the zone affiliation of the paired sensor node
that determines which other nodes will receive the message. This configuration is best suited in larger installations (≥10
sensor nodes) where you want to continuously dim the light up or down. Since the IR messages is distributed from a single
sensor node, the risk of a message being copied is reduced and dimming becomes more stable. Because of this it’s not
recommended to pair more than one node within a zone to the same wall switch. For more information on how to pair a
sensor node and a wall switch, refer to page 23 “Pairing with an EnOcean wall switch”.
Note!
It is of most importance that SN3 nodes with FW (firmware) 181 or later are used. Earlier versions of SN3 nodes do not
have this function. Used the Query function to see what version the node has (Note: Only works with iOS devices).
Switch ID Pairing
Subject to change without notice.
Version5_20200424
Summary of Contents for e-Sense Organic G3
Page 1: ...e Sense Organic G3...
