24
When using Switch ID Pairing or Switch ID Pairing One to One you need to pair the
EnOcean wall switch with one or several sensor nodes.
1. Start by configuring the wall switch with the right functions according to the
steps on page 20.
2. If “One to One” functionality is to be used, tap the box in the app. Note that
after a successful pairing you can easily switch between these configurations by
only reconfigure the wall switch with NFC, no new pairing is needed.
3. Open the menu “Node Interface”.
4. Point the IR-Dongle towards the sensor node and press “Prepare to Pair”. The
sensor node is now ready for pairing for 60s which is indicated by the dome tur-
ning red.
5. Press any button on the wall switch three times within this time to pair.
6. A successful pairing is indicated when the sensor node flashes red twice. A
failed paring is indicated when the sensor node flashes three times.
You can pair an Enocean wall switch to more than one sensor nodes simultan-
eously. There’s no limitation in number of paired nodes to one wall switch. The
switch can only communicate with paired nodes within range of the RF (around
10m).
Note!
A sensor node can be paired to a maximum of two different wall switches.
Delete Pairing
It is also possible to erase the pairing between a sensor node and an EnOcean switch. This can be done in two ways.
Prepare to Unpair
1. Point the IR-Dongle towards the sensor node and press “Prepare to Unpair”. The sensor node is now ready to delete a
paired switch for 60s which is indicated by the dome turning red.
2. Press any button on the wall switch three times within this time to unpair.
3. A successful pairing is indicated when the sensor node flashes red twice. A failed paring is indicated when the sensor
node flashes three times.
Reset to Default
1. Point the IR-Dongle towards the sensor node and press “Reset to Default”. This function will return the node to its
“Default state” which is Zone pairing mode. This function, whether the node is in Zone Pairing mode or Switch ID Pairing
Mode, will also erase any pairing between the sensor node and an EnOcean wall switch.
Subject to change without notice.
Version5_20200424
Summary of Contents for e-Sense Organic G3
Page 1: ...e Sense Organic G3...
