56
You can always turn on the Bridge function manually.
In order to activate the Bridge function touch sensor of the cooking zone and then simulta-
neously touch two sensors of the cooking zones on the left or right side. The rear cooking
zone display will show " ", while the front cooking zone display will show "0". The desired
heat setting is selected by sliding your finger across the setting selection sensor field
.
In order to deactivate the Bridge function touch and hold sensor of the cooking zone with
symbol „ ” for 3 seconds. The respective cooking zone displays will show "0".
Now both cooking zones can be controlled independently.
Check if cookware is suitable for a cooking zone
You can check if your cookware is suitable for a cooking zone to achieve maximum efficien
-
cy and use the full power of the cooking zone.
Test procedure:
• Pour a little water into your cookware and place it in the middle of the cooking zone.
• Turn on the hob.
• When cookware is detected, simultaneously touch and hold for 3 seconds the detected
cooking zone selector and then touch sensor until you hear a beep
• The and symbols will alternate on the display indicating that test is in progress.
• After the test (max. 20 seconds) the display will show a result ranging from 00 to 99.
•
The hob will turn off automatically.
Do not move the cookware during the test.
The result of 99 indicates that cookware is ideal for use on a cooking zone.
The result displayed is indicative only and depends on cookware base diameter,
material and how it is built.
You can use cookware when the result is 60 or more. If the cookware base diameter
is less than that of the cooking zone and the result is below 60, repeat the test on a
smaller available cooking zone. If you use cookware with test result below 60, cooking will
take longer and will be less efficient.
Test result of 00 means that cookware is not suitable for use with an induction hob.
OPERATION
