INSTALLATION
UK
5
In case of a gas leakage:
immediately close the valve of the gas system or gas bottle
ventilate the room thoroughly
call gas service
During this time do not:
light matches or smoke
turn on or turn off electrical devices (radio, door bell, light) or mechanical devices that
spark.
If the gas coming out of a leaky valve of the gas bottle will ignite, put a wet blanket on the
bottle to cool it and then close the valve.
DO NOT USE A DAMAGED GAS BOTTLE!
Never use the hob if its supply wire or plug is broken.
Warning !
Should you find any crack on the electric plate, immediately disconnect the hob
from the electric system and call an authorised service personnel.
1.5
PREPARATION
1. Remove all packaging items, including protective layers, from chromed elements and stainless steel
parts.
2. Wipe enamelled surfaces with a soft, damped cloth.
3. Make sure that all parts of burners are positioned correctly.
4. Before the first use, turn the electric plate ON for approx. 5 minutes by turning the knob to position
"
6
", exceptionally without any pot or pan. During this time the protective layer on the plate will burn
out. When the plate has cooled down, wipe the plate with a dry cloth.
2
INSTALLATION
2.1
GENERAL NOTES
Attention !
1.
This hob must be installed and repaired only by an authorised fitter according to
the manufacturer’s instructions.
2.
Before installation, disconnect the hob from the electric supply.
After unpacking, make sure that the hob has no visible damage and the power cord is in good
condition. If there is a damage, please contact our Customer Service.
This hob may be installed on a worktop that is at least 30mm thick (Fig. 5). The worktop must be
heat-resistant.
The wall next to the rear side of the hob should be made of incombustible material.
A minimum distance of 100mm must be maintained between the side edges of the hob and any
adjacent furniture.
To reduce negative impact of draught on burner operation, do not install this hob on the window-door
line.
There should be a free space left over the hob for discharging fumes. The best solution is to install a
cooker hood which will absorb and discharge these fumes. The minimum distance between the hob
and cooker hood is 650mm.
