5
Door racks
2. Remove the upper cover on the top of
the refrigerator starting from the right
side and then remove the upper cover of
the upper door.
4. Remove the upper hinge by removing the
three self-tapping screws indicated in the
image below.
Note:
Please hold the upper door by hand
during step 4 to prevent door from dropping.
5. Remove the upper door by lifting
vertically and place it on a smooth
surface with the panel facing upwards.
Remove the handle screw covers and
screw hole covers, then remove the self
tapping screws. Remove the handle and
switch it to the right side, then install
the self-tapping screws, handle screw
covers and screw hole covers.
Loosen the self-tapping screws, detach
the stop block and door holder. With the
handle in place, reinstall the door holder
and the spare stop block found in the
plastic bag. Do not use the one you just
removed, that one must be stored in the
plastic parts bag.
Then remove the corner cover and the
upper hinge cover, this may require you
to slightly open the door. Put all parts
into the plastic parts bag.
3. Disconnect all the wiring harness
connectors and ground wires.v Remove
cover on the cabinet body shown in
image 3.
