CLEANING AND MAINTANANCE
GB
14
CAUTION !
1.
The hinge bow is tense with a big strength, therefore while taking out the door a
special care must be taken not to cut one’s own fingers.
2.
During cleaning the upper wall of the oven you should pay attention to electric
heaters, temperature sensor and lamp of the oven illumination; do not change
position of sensor setting.
3.
Do not pour water onto the bottom of oven otherwise it may trickle through some
possible leakage and get on the lower heater.
6.3.2
DISASSEMBLY OF SIDE CATALYTICAL SHIELDS
a)
b)
Fig. 21
To disassembly the side catalytical shields you must first disassembly the guides.
Disassembly of guides:
−
gently press the ladder bar
1
down and take it from beneath the blocking cap
2
, (fig. 21a),
−
turn aside the guides
4
, lift and take them off from the oven openings (fig. 21b),
−
take the catalytic shields
3
out.
6.3.3
CLEANING OF CHAMBER INTERIOR
After removing the catalytical shields you can clean the inside of the chamber. Clean the enamelled
surfaces with agents intended for cleaning cookers. In order to clean baked stains you can use special
detergent intended for cleaning ovens. Since these detergents are caustic, you should use them in minimal
amounts and with a great caution, observing the recommendations of detergent manufacturer.
CAUTION !
A special cleanser for oven you can use only for enamelled surface. Do not clean with
it catalytic enamel shield.
When the oven is cleaned, in the ovens with ladder guides refit the catalytic shields and runners in the
reverse order.
CAUTION !
During assembly you should pay attention if the guides are fastened on the right wall
of oven. The bar limitating insertion of the sheet or net in chamber should be behind
the rear hanging of the guides.
3
4
1
2
Summary of Contents for CFF-4VC
Page 33: ...GB 16...
