Work modes
32
Block search
Using block search, it is possible to restore the program history
up to a particular block in such way that if the program is
executed from that block on, it will do so under the same
conditions as if it were executed from the beginning.
• The automatic block search may be used to recover the
program history up to the block where the previous
execution was canceled. The CNC remembers in which
block the execution was interrupted, thus not being
necessary to set the stop block.
• The manual block search may be used to recover the
program history up to a particular block of the program or
of the subroutine, set by the operator.
Executing block search.
1. Selecting the type of search: automatic or manual.
2. Selecting the stop block. In the automatic block
search, there is no need to select the stop block; by
default, the CNC runs the search up to the block
where the program was interrupted.
3. Selecting the starting block for the search. If the first
block is not selected, the block search starts at the
beginning of the program.
4. Press the [CYCLE START] key to start the block
search.
5. Depending on how the treatment of functions M, H,
F, S is configured, it may be necessary to decide
which ones are sent out to the PLC.
6. Reposition the axes to the point to resume execution.
7. Tool inspection may be accessed to change the
machining conditions.
8. Press [START] to execute the program.
Summary of Contents for CNC 8060
