Work modes
37
Program simulation
Select a program.
The "Open program" softkey is used to select a program
in EDISIMU mode and may be a new program or an
existing one. A different program may be edited and
executed in each channel. When selecting this option,
the CNC shows a list of the available programs.
1. Select the folder that contains the program. If it is a
new program, it will be saved in this folder.
2. Select the program from the list or write its name in
the bottom window. To edit a new program, write the
name of the program in the lower window and the
CNC will open an empty program or a predefined
template depending on how the editor is configured.
Note: depending on the name of the program and the
configuration of the editor, editing is directly activated
in 8055 mode.
3. Press [ENTER] to accept the selection and open the
program or [ESC] to cancel it and close the program
listing.
Summary of Contents for CNC 8060
