Work modes
38
Simulating a program.
1. Choose the type of graphic representation, its
dimensions and the point of view. This data may also
be modified during the simulation of the program.
2. Activate the desired simulation options using the
softkey menu.
3. Press the START softkey to start the simulation. The
simulation may be interrupted with the STOP softkey
or canceled using the RESET softkey.
The simulation of the program starts at the first block of
the program and ends after executing one of the end-
of-program functions "M02" or "M30". As an option, it is
possible to define the first and last blocks of the
simulation. To simulate the program, the CNC assumes
the real configuration of the spindles of the channel and
the configuration of the machine parameters.
“Single block” simulation. The program may be
simulated in –single block– or –automatic– mode; the
mode may be selected even while simulating the
program.
The horizontal menu that appears during a graphical
simulation is dependent upon whether the cursor is in
the graphic section (options for handling graphics,
measurement, etc.) or in the program section (choose
initial block, stop block, etc.).
Summary of Contents for CNC 8060
