CNC8070
R
EF
. 0402
OF
128
E
RROR
SOLUTIONS
Page 114 of 128
Errors 8000-8999
8239
'"Y" programmed twice'
DETECTION
During editing.
CAUSE
The Y axis has been programmed more than once in the block.
SOLUTION
Program the Y axis only once in the block.
8240
'"Z" programmed twice'
DETECTION
During editing.
CAUSE
The Z axis has been programmed more than once in the block.
SOLUTION
Program the Z axis only once in the block.
8241
'Parameter out of range'
DETECTION
During execution.
CAUSE
The programmed value for the parameter of the instruction is too high.
SOLUTION
Program a smaller value for the parameter of the instruction.
8242
'Bracket missing'
DETECTION
During editing and execution in MDI.
CAUSE
The possible causes are:
• The parameters of the programmed instruction must be between brackets.
• The variable requires programming an index between brackets.
SOLUTION
Check the syntax of the instruction or variable in the programming manual.
8243
'"I" programmed twice'
DETECTION
During editing.
CAUSE
The I axis has been programmed more than once in the block.
SOLUTION
Program the "I" value only once in the block.
8244
'"J" programmed twice'
DETECTION
During editing.
CAUSE
The J axis has been programmed more than once in the block.
SOLUTION
Program the "J" value only once in the block.
8245
'"K" programmed twice'
DETECTION
During editing.
CAUSE
The K axis has been programmed more than once in the block.
SOLUTION
Program the "K" value only once in the block.
8247
'Only R1 can be part of an expression'
DETECTION
During editing.
CAUSE
The radius value has not been programmed correctly.
SOLUTION
The radius can only be programmed with "R" or "R1".
8250
'Axis variable without writing permission'
DETECTION
During editing.
CAUSE
An attempt has been made to write an axis variable that does not have a writing
permission.
SOLUTION
The variable can only be read.
8251
'Global variable without writing permission'
DETECTION
During editing.
CAUSE
An attempt has been made to write a global variable that does not have a writing
permission.
SOLUTION
The variable can only be read.
8253
'Axes missing in G20'
DETECTION
During editing.
CAUSE
Not all the parameters required by function G20 have been programmed.
SOLUTION
Check the G20 programming syntax.
Summary of Contents for CNC8 070
