Fagor CNC8 070 Error Code List Download

Page: 19 / 134

CNC8070

. 0402

RROR

SOLUTIONS

Page 13 of 128

Errors 1000-1999

1040

'Home search not allowed on an axis in G201'

DETECTION

During execution.

CAUSE

An axis cannot be homed if it is in additive manual mode (G201).

SOLUTION

Use function G202 to cancel the additive manual mode of the axis in order to home
it. Then, activate function G201 again if you wish.

1041

'Corrected circular path center out of range'

DETECTION

During execution.

CAUSE

A circular interpolation has been defined:

• Using the radius "R" or "R1" and the coordinates of the end point.
• Using the coordinates of the middle and final points being function G265

(correction of the center of the circle) active.

The coordinates values of the center of the interpolation calculated by the CNC are
too large.

SOLUTION

The values programmed in the block for the middle or final points for the interpolation
radius are too large.

1043

'The third axis of the plane cannot be the same as the first or the second one'

DETECTION

During execution.

CAUSE

Parameter 5 programmed in function G20 (plane change) is the same as 1 or 2.

SOLUTION

If the longitudinal axis of the tool (parameter 3) is the same as the first or second axis
of the plane (parameters 1 and 2), the third axis must be programmed with parameter
5. This parameter must not be the same as the first or the second one.

1044

'The first and second axis of the plane cannot be the same'

DETECTION

During execution.

CAUSE

Using function G20 (plane change) the same axis has been programmed as the first
(parameter 1) and the second (parameter 2) axis of the plane.

SOLUTION

Check the program.

1045

'The first axis of the plane has been programmed wrong'

DETECTION

During execution.

CAUSE

Using function G20 (plane change) the first axis of the plane (parameter 1) has been
programmed wrong.

SOLUTION

The first axis of the plane must be one of the main three axes of the configuration.

1046

'The second axis of the plane has been programmed wrong'

DETECTION

During execution.

CAUSE

Using function G20 (plane change) the second axis of the plane (parameter 2) has
been programmed wrong.

SOLUTION

The first axis of the plane must be one of the main three axes of the configuration.

1047

'A third axis is required for the plane (index 5) '

DETECTION

During execution.

CAUSE

Parameter 5 programmed with function G20 (plane change) missing or wrong.

SOLUTION

If the longitudinal axis of the tool (parameter 3) is the same as the first or second axis
of the plane (parameters 1 and 2), the third axis must be programmed with parameter
5 which must not be the same as the first or the second one and must be one of the
main three axes of the configuration.

1048

'Tool length compensation with radius out of range'

DETECTION

During execution.

CAUSE

The tool dimensions exceed the maximum values.

SOLUTION

Modify the tool dimensions.

1049

'Face axis (FACEAXIS) defined twice in the active plane'

DETECTION

During execution.