CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 33 of 128
Errors 1000-1999
1265
'Programming not allowed while RTCP/TLC is active'
DETECTION
During execution.
CAUSE
An attempt has been made to execute one of the following functions while RTCP or
TLC is active.
• Home search (G74).
• Modify software limits (G198 - G199).
• #OSC instruction.
• #KIN ID instruction.
SOLUTION
First cancel the active incline plane, then execute the desired instructions and finally
activate the incline plane again.
1266
'The TLC feature is deactivated using the instruction #TLC OFF'
DETECTION
During execution.
CAUSE
While #TLC is active, a #TLC instruction other than #TLC OFF has been
programmed.
SOLUTION
To program #TLC ON again to change the value programmed earlier, it must be
canceled first using #TLC OFF.
1268
'#CS ON/#ACS ON: syntax error'
DETECTION
During execution.
CAUSE
The syntax of the instruction is wrong.
SOLUTION
Check the syntax of the instruction in the programming manual.
1269
'#CS ON/#ACS ON: the programmed angle is not valid'
DETECTION
During execution.
CAUSE
Programmed angle is not valid.
SOLUTION
The angle programmed in the instruction must be within ± 360º.
1270
'The coordinate transformation cannot be calculated'
DETECTION
During execution.
CAUSE
An attempt has been made to make a coordinate transformation from part to machine
or from machine to part that is not solved.
SOLUTION
Cancel the transformation, change the position to be accessed and activate the
transformation again.
1271
'The axes of the active kinematics can neither be excluded nor modified'
DETECTION
During execution.
CAUSE
Having an active kinematics, an attempt has been made to change the axes that affect
that kinematics using the instructions #CALL AX, #SET AX, #FREE AX.
SOLUTION
Cancel the kinematics before changing the axes of the channel. #KIN ID [0].
1272
'The axes of the active transformation can neither be excluded nor modified'
DETECTION
During execution.
CAUSE
Having an active incline plane, an attempt has been made to change one of the first
three axes that affect that transformation using the instructions #CALL AX[ ], #SET
AX[ ], #FREE AX[ ].
SOLUTION
Cancel the transformation of the incline plane before changing the axes of the
channel. #CS/ACS OFF ALL
1277
'The resulting zero offset exceeds the data range'
DETECTION
During execution.
CAUSE
The zero offset calculated from the coordinates programmed with function G92 is too
large.
SOLUTION
Check the program.
Summary of Contents for CNC8 070
