CNC8070
R
EF
. 0402
E
RROR
SOLUTIONS
Page 35 of 128
Errors 1000-1999
1288
'Too many parameters programmed in the instruction'
DETECTION
During execution.
CAUSE
The instruction has not been programmed correctly.
SOLUTION
Check the syntax of the instruction in the programming manual.
1290
'I, J, K coordinates programmed wrong'
DETECTION
During execution.
CAUSE
The probable causes are:
• The programmed values for the center of the circular interpolation, Polar origin
or center of rotation of the coordinate system are too high.
• Wrong values have been programmed for the coordinates of the center of the
circular interpolation being G264 active.
SOLUTION
Check the program.
1291
'No more S functions allowed'
DETECTION
During execution.
CAUSE
The maximum number of S functions allowed in the same block has been exceeded.
SOLUTION
The maximum number of S functions allowed in the same block is 4.
1292
'M function programmed twice'
DETECTION
During execution.
CAUSE
An M function that is not related with the spindle has been programmed more than
once in the same block.
SOLUTION
Program them in different blocks.
1293
'H function programmed twice'
DETECTION
During execution.
CAUSE
An H function has been programmed more than once in the same block.
SOLUTION
Program them in different blocks.
1301
'The tool length transformation exceeds the valid numeric format'
DETECTION
During execution.
CAUSE
The maximum numeric format has been exceeded in the tool length transformation.
SOLUTION
Modify the values of the transformation or those of the tool.
1302
'Wrong character in the name'
DETECTION
During execution.
CAUSE
The possible causes are:
1. Wrong character in the name of a label.
2. Wrong character in the name of a subroutine.
3. Wrong character in the name of an external variable.
SOLUTION
Valid characters in each one of the previous cases:
1. All except quotes, "]" and tab.
2. All except quotes, blank space and tab. All characters after the "(" will be
considered as part of the comment.
3. letters, digits and the "_" character.
1303
'Variable name too long'
DETECTION
During execution.
CAUSE
Defining "part" as each set of characters separated by "." in the name of a variable,
the error comes up when a part has more than 13 characters.
SOLUTION
Shorten the name of the variable.
1304
'Wrong spindle speed'
DETECTION
During execution.
CAUSE
The programmed spindle speed value is too low.
SOLUTION
The value of the spindle speed must be higher than 1.6 10E-7 rpm.
Summary of Contents for CNC8 070
