Fagor CNC8 070 Error Code List Download

Page: 54 / 134

CNC8070

. 0402

128

RROR

SOLUTIONS

Page 48 of 128

Errors 1000-1999

1434

'An associated slave axis could not be included in the configuration'

DETECTION

During execution.

CAUSE

The instruction #CALL AX or #SET AX has been used to include in the system
configuration the master axis of an active coupling (#LINK) or that of a Gantry pair.
When including the master axis, the slave axis is also included automatically and it
can never occupy one of the main three positions of the channel. The error is issued
because there is no free position other than the main three for the slave axis.

SOLUTION

In order to only include the master axis, the active coupling must be deactivated first
(#UNLINK) or undo the Gantry pair.

In order to include both the master and the slave axis, first eliminate another axis from
the channel or increase the number of axes of the channel.

1435

'An associated slave axis could not be assigned a name because it was repeated'

DETECTION

During execution.

CAUSE

The instruction #CALL AX or #SET AX has been used to include in the system
configuration the master axis of an active coupling (#LINK) or that of a Gantry pair.
When including the master, the slave axis is also included automatically. The error
comes up because the name of the slave axis is already occupied by another axis
of the current configuration of the channel.

SOLUTION

Rename either the slave axis to be included or the one that already exists in the
configuration.

1436

'The stop block has not been programmed in the block search'

DETECTION

During execution.

CAUSE

The option to execute the program in block search has been selected, but the final
block of that execution has not been indicated.

SOLUTION

Once the block search option has been selected, it shows the stop block option. Select
the block where the block search will end.

1439

'The axes of the active transformation cannot be Hirth'

DETECTION

During execution.

CAUSE

An attempt has been made to activate an axis transformation (#TLC, #RTCP, #TOOL
ORI, #CS or #ACS), but one of the axes involved in the transformation is a Hirth axis.

SOLUTION

For the axis to be able to be part of the transformation, it must not be a Hirth axis;
therefore, set its machine parameter HIRTH = NO.

1441

'The kinematics has not been activated'

DETECTION

During CNC power-up or parameter validation.

CAUSE

There is a kinematics that must activate, but it doesn't either because it is an unknown
kinematics or because the axes required for that kinematics are not the right ones.

SOLUTION

Make the value of the type of kinematics to be activated a valid value and make sure
that the axes involved in it are properly defined. The axes must always be the first
ones of the channel, they must not be Hirth, they must not be parked and they must
not be slaves of a coupling or a gantry pair.

1442

'The kinematics has been deactivated'

DETECTION

Warning during reset or at the beginning of the program.

CAUSE

There is a kinematics that has been deactivated, either because it is an unknown
kinematics or because the axes required for that kinematics are not the right ones.

SOLUTION

1443

'#CS/ACS has been deactivated'

DETECTION

Warning during reset or at the beginning of the program.

CAUSE

The axes required for the transformation of an incline plane are not the right ones.

SOLUTION

Make sure that the main three axes of the channel are defined, linear, unparked and
not slaves of a coupling or a gantry pair.