Fagor CNC8 070 Error Code List Download

Page: 79 / 134

CNC8070

. 0402

RROR

SOLUTIONS

Page 73 of 128

Errors 1000-1999

1839

'Pocket with islands: Wrong intersection of XY profiles'

DETECTION

Execution of a 2D or 3D pocket cycle with islands.

CAUSE

Two XY profiles have at least some straight or arc section in common.

SOLUTION

Check that the intersections of all the XY profiles only take place on points, never on
sections.

1840

'Pocket with islands: Not enough memory to resolve it'

DETECTION

Execution of a 2D or 3D pocket cycle with islands.

CAUSE

There is no system memory left to continue resolving the pocket.

SOLUTION

1841

'Wrong tool position before the canned cycle'

DETECTION

Executing a canned cycle.

CAUSE

Before executing the canned cycle, the coordinate of the tool tip along the longitudinal
axis (Z) is located between the reference plane and the surface of the part.

SOLUTION

Move the tool along the longitudinal axis (Z) to get it out of the safety area delimited
by the reference plane and the part.

1842

'Tool diameter smaller than DELTA'

DETECTION

Executing a canned cycle.

CAUSE

The diameter of the finishing tool is smaller than the finishing pass (DELTA).

SOLUTION

Choose a tool whose diameter is greater than the finishing pass or decrease the
finishing pass (DELTA).

1843

'Pocket with islands: Wrong roughing tool radius'

DETECTION

Execution of a 2D or 3D pocket cycle with islands.

CAUSE

The radius of the tool programmed in the roughing operations or roughing at the
bottom has a value of 0. Or the radius of the tool is too large for the geometry of the
pocket, taking into account the lateral finishing stock to be left.

SOLUTION

If the tool radius is not 0, check that the value programmed in the finishing stock is
correct. In this case, a tool must be programmed with a smaller radius than the current
one.

1844

'Pocket with islands: Wrong finishing tool radius'

DETECTION

Execution of a 2D or 3D pocket cycle with islands.

CAUSE

The tool radius programmed in the finishing pass has a value of 0 or it is too large
for the geometry of the pocket.

SOLUTION

If the tool radius is no t0, program a tool whose radius is smaller than the current one.

1845

'G165: Chord length (I) greater than the diameter'

DETECTION

Execution of the canned cycle G165.

CAUSE

The length of the chord defined in parameter I is greater than the diameter of the circle.

SOLUTION

Assign a correct value to the I parameter.

1846

'Zero arc radius'

DETECTION

Execution of multiple machining in an arc.

CAUSE

In the cycle editor, an arc has been programmed with a zero radius or an arc whose
center coordinates Xa and Ya are the same as the XY coordinates of the cycle that
is going to be repeated.

SOLUTION

Program an arc whose radius is not zero; in other words, assign other values to
parameters Xa, Ya or R.

1847

'RECTANGULAR BOSS :Q = 0'

DETECTION

Execution of rectangular boss canned cycle.

CAUSE

The material to be removed in the work plane to make the boss has not been defined.

SOLUTION

Assign to Q a value other than 0.

1848

'CIRCULAR BOS S :Q = 0'