Fagor DH-10D, Instructions For Use Manual

13

6. DRAINING OFF THE 

CONDENSATION WATER

WATER TANK

•

Every few weeks, clean  the  water tank 
to prevent growth of mold, mildew and 
bacteria. Partially fill the  water tank 
with  clean  water and add a little mild  
detergent. Swish it around in the  water 
tank, empty and rinse.

NOTE: 

Do not use a dishwasher to clean  

the water tank. After clean, the water 
tank must be in place and securely 
seated for the  dehumidifier to operate.

•

When the water tank is full, the unit will 
automatically stop running, and the Full 
indicator light goes on. Slowly pull out 
the water tank. Grip the left and right 
handles securely, and carefully pull out 
straight so water does not spill. Do not 
put the water tank on the floor because 
the bottom of the water tank is uneven.

•

Otherwise the water tank will fall and 
cause the water to spill.

•

Throw away the water and replace the 
water tank. The water tank must be 
in place and securely seated for the 
dehumidifier to operate.

NOTE:

 The machine will re-start when 

the water tank is restored in its correct 
position.

to 80 % RH (Relative Humidity) in 5% 
increments.

For drier air, press the – pad and set to a 
lower percent value (%).

For damper air, press the + pad and set 
to a higher percent value (%).

G   Continuous pad
 

Select for the dehumidifier to 
operate continiuously for maximum 
dehumidification until the watertank 
is full. The humidity set control pads 
cannot be used when continuous 
operation is on. Press this pad again to 
cancel continuous operation. 

NOTE: After the +/-/continuous pad is 
pressed, the unit can not be restart the 
operation in 6 minutes.

CONNECTION FOR CONTINUOUS 
DRAINAGE
•

Water can be automatically emptied into 
a floor drain by attaching the unit with a 
water hose (Ø 12 mm) (not included).

•

Remove the rubber plug from the back 
of the unit and store it in a safe location.

•

Insert the water hose into the unit from 
the drain outlet in the back of the unit 
as shown in Fig. 3. Attach the water 
hose to the drain hose outlet of the unit. 
Maker sure the connection of the water 
hose and the drain hose outlet of the 
unit is tight and do not let the water leak.

•

Then lead the water hose to the floor 
drain or a suitable drainage facility. The 
drainage facility should be lower than 
the drain outlet of the unit.

•

Be sure to run the water hose sloping 
downward and let the water to flow out 
smoothly. 

 NOTE: 

When the continuous drain 

feature is not being used,remove the 
drain hose  from the outlet and attach 
the rubber plug back to the drain outlet.

7. MAINTENANCE AND CLEANING

Unplug the appliance before carrying out 
any maintenance or cleaning.
Clean the outside of the appliance with a 
soft damp cloth.
Do not use water, solvents or similar 
substances to clean the appliance. Do not 
use abrasive cleaning agents.

CLEAN THE AIR FILTER 

The air filter behind the  front grille should 
be checked and cleaned at least every 30 
days or more often if necessary.

NOTE: DO NOT RINSE OR PUT 
THE FILTER IN AN AUTOMATIC 
DISHWASHER.

- To 

remove:

•

Pull the  water tank out  as shown  in 
Fig. 2.

•

Grip the tabs on the filter and press 
them in slightly to take them out from 
the  filter holder, then pull out the  filter 
downward.(see Fig. 4-5).