Operation Manual
NV-300T/301T Man: 9910 Soft: 2.xx
INTRODUCTION
Throughout this manual, certain installation parameters are referred to which
affect the description of certain DRO functions.
These parameters have been set by the installer and may be modified by the
operator.
These parameters are described in the installation manual supplied with this
unit.
INDEX
Unit description .............................................................................1
Front panel .....................................................................................1
Rear panel .......................................................................................4
Coordinate display .......................................................................6
Display modes ................................................................................6
Incremental, absolute and with respect to machine reference zero .....7
Machine reference selection and search ............................................9
Axis coordinate preset ...................................................................11
Special operations .......................................................................13
Scaling factor ................................................................................13
Tool Preset ....................................................................................14
Deleting all tool offsets .................................................................14
Coordinate freeze (Hold) ...............................................................15
Taper (cone) calculation ................................................................15
Appendix ................................................................................................16
Error codes ...............................................................................................16
Maintenance .............................................................................................17