EN
78
FAULT
POSSIBLE CAUSE
ACTION
Dishes and
kitchenware are
not dry.
There is no rinse aid
Fill the rinse aid container.
Insufficient rinse aid.
Call the technical service to reset the dispenser.
Dishes left inside dishwasher for too
long.
Remove the dishes at the end of the wash cycle and
leave to dry by evaporation for a minute.
Rinse temperature lower than 80 ºC /
176
⁰
F.
Allow the boiler to reach the rinse temperature before
starting the cycle. If the problem persists, call the
technical service.
Dishes stained
or scratched.
Too much rinse aid.
Call the technical service to reset the dispenser.
High water hardness.
Check the water hardness, it should be less than 10
ºfH.
SOFT models: Not enough salt in salt
deposit or incorrect regeneration.
Top up salt container.
If necessary, contact the technical service for the
adjustment of the water hardness setting.
Traces of salt in tub.
When filling the salt deposit, take care not to spill salt
in the tub and clean thoroughly.
Machine stops
during
operation.
Check whether the magneto-thermal
circuit breaker or the differential switch
has tripped.
Reset safety device and if it trips again, call technical
service.
Machine stops
and fills with
water when it is
washing.
Overflow incorrectly mounted.
Mount overflow correctly.
Pressure switch pipe blocked.
Empty the tub and clean thoroughly.
Pressure switch faulty.
Call the technical service to replace it.
Machine does
not start with
the wash cycle.
Hood not closed properly.
Close the hood properly. If the hood opens on its
own, contact the technical service to have the
tensioners tightened.
Hood closed sensor faulty.
Call the technical service to have it repaired.
Machine does
not drain
completely.
Machine not levelled correctly.
Level the machine In the event of doubt, please
contact your technical service.
Pressure switch faulty.
Call the technical service to replace it.
If the fault cannot be found, call the technical support service.
The manufacturer reserves the right to modify the technical characteristics of the
machine without prior warning.
7.1
MOD. “A” & “B” Fault diagnosis
The errors are indicated by an LED error code via the
ON LIGHT (
Fig. 7 & 8
)
, which flashes a set number
of times depending on the error, pauses and then repeats the cycle. For example in Error 3: 3 continuous
flashes and a longer intermediate pause.
ERROR /
FLASHES
DESCRIPTION
DESCRIPTION
1
HOOD OPEN.
A cycle is trying to run with the hood open or the hood is
opened mid-cycle.
2
TANK FILL ERROR.
The tank has not reached the correct water level within 10
minutes.
3
TANK DRAINAGE ERROR.
The drainage pump has not drained the tank in the time
established.
4
BOILER HEATING ERROR
The boiler has not reached the correct temperature in the time
established.
5
TANK HEATING ERROR
The tank has not reached the correct temperature in the time
established.
6
BOILER FILLING ERROR
The boiler has not reached the correct water level in the time
established.
Summary of Contents for evoCONCEPT
Page 14: ...14 MOD A CO 142 MOD B COP 144 ...
Page 15: ...15 MOD C ...
