Fagor Fagor Rapida Pressure Cooker User Manual Download

Page: 18 / 92

Troubleshooting

In order to ensure best results when using the Fagor RAPIDA pressure cooker, be certain
to read all of the instructions and safety tips contained in this owner’s manual and all
other printed materials provided by the manufacturer. The following are practical tips and
solutions to some common problems you may experience when using the Fagor RAPIDA
pressure cooker.

PROBLEM:

REASON:

SOLUTION:

The lid got jammed while trying to slide it closed, and will not open or close.

If the instructions in the “Closing the Lid and Cooking” section of this manual were
not followed carefully, the lid might get jammed while trying to close it.

If there is some resistance when attempting to slide the lid closed, do not force it.
Stop, slide it back, lift the lid and try aligning the marks again as described in the
“Closing the Lid and Cooking” section of this manual.
If the lid jams, never try to force it closed. To un-jam try sliding the lid open again.
If you cannot open it, please contact the Fagor Customer Service Department at:
1-800-207-0806 or email at: info@fagoramerica.com.

PROBLEM:

REASON:

SOLUTION:

There is water leaking from the lower handle while the cooker is building
pressure.

While the pressure cooker is building pressure, a little water might drip from around
the area of the pressure lock on the pot handle. The water comes from steam
condensed on the inside of the lid. The dripping will stop when the pressure cooker
reaches full pressure. However, if it’s a continuous leak, or does not stop after
pressure has been reached, it might be for one of the following reasons:

1. The nuts and screws on the handle have loosened.
2. The gasket has not been oiled.

1. Make sure the lower handle is screwed tight to the pot before using the

pressure cooker or after the all pressure has been released. Tighten the screws
with a screwdriver if necessary.

2. Make sure you wash and dry your gasket after every use, and oil it regularly.

PROBLEM:

REASON:

SOLUTION:

Pressure does not build up (the visual pressure indicator does not pop up after
more than 5 minutes on high heat).

1. There is not enough liquid.
2. The pressure cooker was not properly closed.
3. The valve is dirty and/or obstructed.
4. The silicone gasket is not in place, or is dirty or worn.
5. The operating valve is not in the correct position.

1. Always use the appropriate amount of liquid called for in the recipe. This amount

should never be less than ½ cup. However, never fill the pressure cooker more
than half full with liquids.

2. Following the instructions given in this manual, close the pressure cooker so

that a tight seal is created, which will allow for adequate pressure build-up.

3. The valve can become dirty when cooking foods such as dried beans which

have a tendency to foam. Clean the valve periodically.

4. Make sure the silicone gasket is clean and well positioned before using the pressure

cooker. After continued use, the silicone gasket will begin to wear and should be
replaced at least once a year if the pressure cooker is used frequently.

5. Make sure the operating valve has been turned to the pressure setting (the

picture of a pot). The pressure cooker will not build up pressure if the operating
valve is turned to the steam release position (the picture of the steam).

ENGLISH