Usage of mop
P2-6
01 .Turn over the robot and stick the mop onto the bottom part fitly, refer to P2-6.
02 .Place the robot on the floor and start it as normal.
03 .It is better to clean the mop first and wring up before using.
Attention :Mop is only apply to hard floor, please take it out while the robot cleans on
short-hair carpet.
Usage of water tank
01
、
Pour water into the water tank hole, then cover it with water tank stopper after it is
fulled with water. (make sure there is no water leak out from the water tank stopper), refer
to picture 4-1
02
、
Hold the mop against the bottom of water tank correctly, then paste each edge onto
the bottom uniformly, refer to picture 4-2.
03
、
Align the four fixed pillar of water tankwith the four fixed holes on main body and dust
box, press the water tank down with strength and make it totally fixed inside the bottom of
main body, it means the water tank is installed well. Refer to picture 4-3
04
、
When the water is ran out, please take out the water tank and then pour water again
(Warning:Do not pour water directly without taking out the water tank, it is very easy to wet
the main body, which can infect the normal operation or damage the electric element
inside main body).
05
、
When you need to take out the water tank, grasp the left and right sides of water tank
and pull it out by swing the tank, until the water tank is separated out totally (please do not
swing excessively, otherwise it might damage the machine).
Attention: 1. Please take out the water bank when the robot is in standby or charging. If
you keep the water tank inside machine for a long time, the water inside might leak out
and damage floor.
2.The mop only applied to clean horniness floor, please take it out when the robot is
working on undercoat carpet.
Water-out hole
