41
14
DETERGENT PUMP NEW LOCATION
Be sure your detergent pump has the position shown below. If not, follow instructions to reverse your
pump:
Tools needed:
-
Drill and ¼” drill bit
-
5” Nut driver
-
#2 Philips screwdriver
Procedure:
1-
Open front bottom panel
2-
Remove two screws of rinse aid dispenser to have a better access.
3-
Be sure that the bracket on the pump is the one shown above (part nº: Z208434)
4-
If not, attach pump to the bracket with (2) bolts, (2) washers and (2) nuts supplied
5-
Drill two holes ¼” diameter. 5” and 6” from the bottom and ½” from the left.
6-
Use (2) bolts, (2) washers and (2) nuts supplied to hold the bracket and the pump.
7-
Fit detergent pipes on the pump. Check out above to see which one goes to the tank and which
one goes to the detergent container.
8-
TIGHTEN DETERGENT PIPE CONNECTIONS
9-
Put back rinse aid dispenser in its position
New bracket. Part #:
Z208434
Holes (1/4”) and hardware needed: (2) bolts #Q012031,
(2) washers #Q232030 and (2) nuts #Q162030
Connections must be
tighten, to prevent
leaks
Rinse aid dispenser
is
adjustable too. Turn the
button counterclockwise
to get more liquid
during the rinsing and
clockwise for less
amount.
When machine is new,
in order to prime the
Pipe going to the tank
Pipe going to the detergent container
