10
without programmed working periods
push all the notches towards the
centre. In this case, to turn the
appliance off totally the plug must be
pulled out apart from switching off, so
as to avoid unnecessary working of the
timer.
GB
Your oil filled raditor is absolutely free
from maintenance, fully reliable and will
give many years of trouble free service.
Wipe radiator with soft damp cloth; do not
use detergents or abrasives.
If necessary, use a vacuum cleaner to
remove any built-up dirt.
5. MAINTENANCE
Adjusting the thermostat
The switch and thermostat should be
maintained until the desired room
temperature has been reached. Now
move the thermostat back gradually
until the red pilot lamps go out.
The thermostat can then remain at this
setting. As soon as the room
temperature has dropped below the set
temperature, the heater switches itself
on automatically until the set
temperature has again been reached. In
this way the room temperature remains
constant with the most economical use
of electricity.
• Antifreeze function
Turn the thermostat to the position
and press the switches. The appliance
will maintain a minimum room
temperature of approximately 5°C thus
preventing freezing with a minimum
energy consumption.
c) Models with a 24 hour time-clock
(fig. 9)
To set the heating periods proceed in
the following manner:
- Check the time by your watch.
Supposing it is 10.00 a.m. turn the
numbered dial of the time-clock in a
clockwise direction until the number
10 coincides with the reference mark
on the time-clock. Set the time period
during which you wish the appliance
to work by pushing the notches
towards the centre. Each notch
corresponds to a period of 15 minutes.
At this point sections will be visible
corresponding to the working periods.
Set in this way the radiator will
function automatically every day
during the set period. (Important: the
plug must remain connected to power
supply).
- To change the programmed time
period, just bring back the black
notches to their original position and
set the new working periods required.
- If you wish the appliance to function
impagi.qxd 8-09-2003 12:07 Pagina 10
