11
fagorindustrial.com
4.2.2
Cleaning the Gasket
Gaskets require regular cleaning to prevent mold and mildew build up and
also to keep the elasticity of the gasket. Gasket cleaning can be done with
the use of warm soapy water. Avoid full strength cleaning products on
gaskets as this can cause them to become brittle and prevent proper seals.
Also, never use sharp tools or knives to scrape or clean the gasket which
could possibly tear the gasket and rip the bellows.
Gaskets can easily be replaced and do not require the use of tools or
authorized service persons.
The gaskets can be pulled out of the grove in the door and new gaskets can
be “pressed” back into place.
4.2.3
Draining the Unit
Each unit has a drain located inside the unit which removes the
condensation from the evaporator coil and evaporates it at an external
condensate evaporator pan. Each drain can become loose or disconnected
from moving or bumping the drain.
IF YOU NOTICE EXCESSIVE WATER ACCUMULATION ON THE INSIDE OF THE
UNIT be sure the drain tube is connected from the evaporator housing to
the condensate evaporator drain pan.
IF WATER IS COLLECTED UNDERNEATH THE UNIT you may want to check the
condensate evaporator drain tube to be sure it is still located inside the
drain pan. The leveling of the unit is important as the units are designed to
drain properly when on a level surface, if your floor is not level this can
also cause drain problems. Be sure all drain lines are free of
obstructions; typically food product is found blocking drain lines causing
water to back up and overflow the drain pans.
4.3
Machine disposal
The product’s life-cycle is around 7 to 10 year from the First use an instalation
date.
FAGOR equipment is manufactured without dangerous or toxic materials. Some
parts of the equipments are biodegradable.
The disposing after the product’s life-cycle shall be determined according to the
rules and laws established in the city or State of residence.
REMEMBER TO TAKE CARE OF THE ENVIRONMENT.
