PRACTICAL INSTRUCTIONS FOR INSTALLATION
Instructions for installation
Very important: Read this manual carefully before installing the
refrigerator.
These instructions are designed to be read in conjunction with the
corresponding drawings.
Identification
Identify the height of your refrigerator on the template:
“a” (2027 mm -
79,33”), or “b” (1875 mm - 73,68”).
Installation should only be attempted by a qualified professional.
1.1. Before starting
Main parts required for installing your integrated refrigerator
•
Template (1.1.1)
•
Main clamping frames
(2 units) (1.1.2)
•
Threaded studs and nuts
(4 units) (1.1.3)
•
Runner sets
(4 units) (1.1.4)
•
Lower clamping frames
(4 units) (1.1.5)
Raise the appliance around 3 - 4 cm (1.18" or 1.57") above the base
board. This will make it easier to adjust the appliance (1.1.6, 1.1.7).
To change the direction in which the doors open consult sections
(1.1.8, 1.1.9, 1.1.10, 1.1.11).
When changing the direction of the doors the upper right hinge
becomes the lower left hinge and the lower right hinge becomes the
upper right hinge.
1.2 Fitting the doors.
Fitting the attachments to the appliance
•
Insert the threaded studs into the top of the refrigerator and
freezer doors. When doing so, it is important to leave 5 mm
(0.2") between the intermediate nut and the top of the door
(1.2.1).
•
Position the clamping frames at the bottom of the refrigerator
and freezer door (1.2.2).
Preparing the cabinet door:
Marking the doors (1.2.3): Carefully position the template on the
inside of the cabinet door.
- Freezer door: Position the template (1.1.1) using the top of the door
as a guide (1.2.4). Make the marks indicated with the number 1 at the
bottom and make the necessary marks at the top to attach the main
clamping frame (1.2.5).
- Refrigerator door: Position the template (1.1.1) taking the bottom of
the door as a guide (1.2.6). Make the marks indicated with number 2 at
the bottom and make the necessary marks at the top to attach the main
clamping frame (1.2.7) at height "a" or "b" according to the height of
your refrigerator, then remove the template (1.2.8)
Joining the cabinet door and the main clamping frame:
freezer/refrigerator
•
Match up the holes in main clamping frame with the marks you
have made on the inside of each cupboard door (1.2.9).
•
Attach the clamping frame to the door with the studs in the kit
(1.2.10).
Tighten the main claiming frame
•
Fit the runners into the main clamping frame (1.1.4).
It is important you place the metal part in the bottom
(1.2.11) and the plastic part in the top (1.2.12).
It is important you position the runners exactly as shown
in the illustration.
Clip the runners into the upper slots in the main clamping
frame (1.2.13).
•
Fitting and initial adjustment of the lower door to the
appliance.
Follow these steps with the appliance outside the niche.
- Place the cabinet door in the main clamping frame on the
threaded studs of the lower door of the appliance (1.2.14).
- Insert the studs in the slots and provisionally tighten (1.2.15).
•
Repeat all these steps to fit and adjust the upper door of
the appliance.
Adjustment and alignment of the cabinet doors
Carry out these steps with the appliance fitted inside the
niche.
