64
Power sensors -/+ with compact control sensors
Each heat source has a sensor next to each display (which indicates its
position on the hob). If you act over said sensor the sensor associated to the
last is selected and the corresponding display begins to flash changing its
brightness. The heat source is chosen automatically if you do not act over
any sensors in a 10 second interval.
To change the power of the heat source for dishes, the heat source is chosen
(acting over the sensor associated to the position of said heat source), and
immediately after acting over the + or the – until obtaining the required
power, between 1…9.
OPERATING
Switching off the heat source
Choose 0 power of the heat source you wish to turn off. If the hotplate is hot,
H will light up.
¡Warning!
If a power cut occurs while the residual heat display is on, remenber that
when power is restrored the display will not re-appear even though the
hotplate is still hot.
Residual heat display H
When activated but with level 0, the corresponding displays shows 0 and H
alternatively.
While a hotplate is still hot but switched off, the display will show H.
Depending on the power that was used, this display may remain on for up to
approximately 30 minutes.
Do not touch the area of the hotplate.
There is a risk of burning.
