TAPAS CASES SERVICE MANUAL / Rev. JUN. 2015
Page
6
3.3
DATA PLATE
The data plate is located inside the cabinet, near the top front, left corner. Under no
circumstances should the data plate be removed from the unit. The data plate is essential to
identify the particular features of your machine and i t is of great benefit to installers,
operators, and maintenance personnel. It is recommended that, in the event the data plate is
removed, you copy down the essential information in this manual for reference before
installation. Removal of data plate will void the warranty.
3.4
LEVELING
Set unit in its final location. A level cabinet looks better and will perform better. Effective
condensate removal and door operation will be effected by leveling. Machine must be leveled
front to back and side to side with a level tool. Castors k i t w i l l include shims for leveling.
Insert the shim between the castor and the frame rail. (See installation of castors). Lock front
castors so cabinet does not move. Ensure drain hose is inside drain pan.
3.5
ELECTRICAL CONNECTIONS
Refer to the amperage data in this manual, or on data plate, and your local code or the
National Electrical Code to be sure unit is connected to the proper power source. Verify
correct incoming voltage according to the Data Plate information.
Do not, under any circumstances, cut or remove the ground prong from the power cord.
Fagor units must be properly grounded.
NEVER USE AN EXTENSION CORD! Fagor will not warranty any unit that has been
connected to an extension cord.
Fagor equipment must be grounded and connected in accordance with NEC Article 422
Appliances.
Model
Electrical
Refrigerant Type
SERIAL NUMBER FOR
THE EQUIPMENT
(8 digits and ends in
“M”)
