TAPAS CASES SERVICE MANUAL / Rev. JUN. 2015
Page
7
DANGER: Power must be turned off and disconnected from the power source when ever
performing maintenance, repair or cleaning the condensing unit.
If machine is still running when power is off, disconnect power at the circuit breaker before
unplugging the machine.
WARNING: Machine and compressor warranties are void if failure is due to improper
electrical installation.
4
OPERATION
The temperature displayed by the electronic controller is the temperature of the evaporator
of the unit. The temperature of cabinet will be displayed by the analog thermostat provided.
This display refrigerator is design to keep the product inside cold, under any circumstance
leave food overnight, this will make the evaporator to become frozen and compressor
damage may occur. Damages caused by leaving the unit ON overnight with product will not
be covered under warranty.
4.1
ELECTRONIC CONTROL
After connecting your unit, turn ON rocker switch located next to the controller. The display
will light up showing the temperature inside the unit. Also, the compressor and fan icons will
flash for a period of three minutes. After this delay the unit will start cooling.
Compressor Icon
Evaporator Fan Icon
Temperature inside the cabinet
Verify you don't have any alarms on the temperature controller. If after you turn ON the
equipment the controller shows t h e alarm icon or an error code, call f o r technical service.
They will help you fix the problem.
Note: The controller on the equipment is programmed to display internal temperatures in Fahrenheit (°F). To
