SMART Pressure Transmitter
FT3351 Series User Manual
July.2022
25 |
P a g e
FAHM Co
.
Industrial Automation
Doc. FT3351Rev1401-05
P/IN3
[pound per cubic inch]
T/YRD3
[ton per cubic yard]
UG/L
[micro gram per liter]
UG/M3
[micro gram per cubic meter]
3.2.6.5
Basic parameters
Due to selected mode of device in “Device-Mode” menu item, the device needs some parameter
to calculate the user’s desired variable.
parameter
display
Parameter tuning structure
Liquid Density
(The density of tank
liquid)
Press <M> until this page is appeared on LCD. Then press
<Z> to access the amount of liquid density (programing
mode). You can change the amount of digits by <S> and
change the point and position of digits by <Z>. After
tuning this parameter, press the <Z> until all characters
blink. Then press <M> for the saving new parameter and
switching from programing mode to operation mode
.
Tank Height
(The total height of
tank)
Press <M> until this page is appeared on LCD. Then press
<Z> to access the amount of tank height (programing
mode). You can change the amount of digits by <S> and
change the point and position of digits by <Z>. After
tuning this parameter, press the <Z> until all characters
blink. Then press <M> for the saving new parameter and
switching from programing mode to operation mode
.
Tank Volume
(The total volume of
tank)
Press <M> until this page is appeared on LCD. Then press
<Z> to access the amount of tank volume (programing
mode). You can change the amount of digits by <S> and
change the point and position of digits by <Z>. After
tuning this parameter, press the <Z> until all characters
blink. Then press <M> for the saving new parameter and
switching from programing mode to operation mode
.
Level Offset
(The transmitter
relative to the tank
floor)
Press <M> until this page is appeared on LCD. Then press
<Z> to access the amount level offset (programing mode).
You can change the amount of digits by <S> and change
the point and position of digits by <Z>. After tuning this
parameter, press the <Z> until all characters blink. Then
press <M> for the saving new parameter and switching
from programing mode to operation mode
.
The unit of density is determined in “density unit” menu item.
The unit of tank height and level offset is determined in “level unit” menu item.
The unit of tank volume is determined in “volume unit” menu item.
