PROTECTED UNDER U.S. PATENT D666,453 OTHERS PENDING
9
GRILLA Maintenance and care
caution
:
Periodic maintenance should only be done while the Grilla is shut off and cold. Time
frames are suggestions only; maintenance frequency depends on fuel and the amount of use. Make sure
your Grilla is COMPLETELY COLD before performing any maintenance.
Auger Removal/Installation
Fire Pot Removal/Installation
Igniter Removal/Installation
Cleaning
Protecting Your Grilla
1. Unplug Grilla.
2. Empty Hopper.
3. Remove Maintenance Cover (58).
4. Unplug Grill Auger Motor.
5. Remove Auger Strap (53).
6. Remove single screw at the bottom of the Auger
Screw Assembly (55).
7. Slide Auger Screw Assembly out.
8. Reverse steps for re-installation, ensuring Auger
Strap (53) is between the 12 o’clock and 2 o’clock
position when installed.
1. Turn Grilla “Off."
2. Remove Lower Cooking Grate (16), Grease Can
Holder (11) and Flavor Disc (29).
3. Remove 4 screws.
4. Rotate Fire Pot 90° and lift up and out.
5. Reverse steps to install and ensure the Igniter goes
into the Fire Pot, exposing the Igniter in the Fire Pot.
1. Complete “FIRE POT REMOVAL/
INSTALLATION” above. Note—remove zip tie
for wire harness behind rear service panel.
2. Pull wires out to expose connectors and unplug.
3. Loosen collar screw.
4. Slide Cartridge Heater out.
5. Call Grilla Grills for replacement part.
6. Reverse steps for re-installation.
• Do not use oven cleaner, abrasive cleansers or abrasive cleaning pads on the outside Grilla surfaces.
Use warm soapy water to cut the grease.
• Clean Hopper, Burn Pot, and Burn Chamber after every 5 bags of fuel, or as necessary. Clean RTD
probe (inner temperature probe) regularly.
• Use a protective cover on your Grilla after each use.
Make sure Grilla is COMPLETELY COOL before
covering. A Grilla Cover is highly recommended!
• If the Grilla is stored outside, care should be
taken to ensure that water does not get into the
Hopper. Wood pellets, when wet, expand and
will jam the Auger.
• Use touch-up paint to repair any scratches.
• Grilla Covers and touch-up paint are available
through GrillaGrills.com.
• You should thoroughly clean and inspect your
Grilla on a regular basis.
For more Grilla Maintenance and Care
information, visit GrillaGrills.com
