GRILLA PELLET SMOKER GRILL
OPERATION MANUAL
10
The Grilla is very trouble free in operation when properly maintained and quality fuel is used. If the Grilla fails to operate
properly, use the following to troubleshoot.
How do I remove the auger if it jams?
1.
Unplug Grilla
2.
Empty Hopper and clean out Auger with vacuum as necessary to remove any loose debris
3.
If Auger still will not turn see “AUGER REMOVAL” section on page 9 under “Grilla Maintenance and Care”
4.
Once Auger has been removed clean tube and Auger and re-install
5.
Plug Grilla in and turn “On”
6.
If the Auger still won’t turn, motor may need replacing, contact your local Grilla dealer
Why won’t my Grilla light?
1.
Check outlet and verify Control Panel is powering up
2.
If outlet is good and LED Screen is not coming on, check fuse on back of Control Panel (see “CONTROL PANEL
REMOVAL” section on page 9 under “Grilla Maintenance and Care”)
3.
Turn Grilla “Off”
4.
Remove Lower Cooking Grate (16), Grease Catch Can Holder (11) and Flavor Disc (29)
5.
Remove Fire Pot (see “FIRE POT REMOVAL/INSTALLATION” section on page 9 under “Grilla Maintenance
and Care”) and clean
6.
Re-install Fire Pot
7.
Turn Grilla “On”
8.
Verify Auger begins to turn and fuel is dropping into Fire Pot. If Auger is not turning see “How do I remove the Auger if it
jams?” section above
9.
If Auger is turning but pellets are not coming out ensure there are pellets in the Hopper if it ran empty or this is
the first time for use, it will be necessary to prime the Auger (see “GETTING STARTED” section page 5 for directions).
This will ensure pellets are at the end of the tube and will begin dropping once unit is turned on
10.
Igniter should begin to turn red within 1-2 minutes. If not see IGNITER REMOVAL/INSTALLATION (page 9)
11.
The Grilla can be used without the Igniter by simply following the “How to manually light your Grilla” section
Pellets are not being delivered into the Fire Pot, why?
1.
Verify pellets are in the Hopper
2.
If this is the initial firing or the Grilla has run out of pellets, allow sufficient time for the pellets to travel from the Hopper to
the Fire Pot (may take up to 5 minutes)
3.
Once pellets begin to drop, turn the Grilla “Off” and then back “On” to re-start Ignition Mode (see step 3 and 4 in
“GETTING STARTED” section on page 5)
4.
Ensure the Auger is turning by removing the Lower Cooking Grate, Grease Catch Can Holder and Never Flare Flavor
Disc and visually checking the Auger
5.
If Auger is not turning see “How do I remove the Auger if it jams?” section above
TROUBLESHOOTING AND FAQ
