- 12 -
10 - MAINTENANCE
11 - REPLACEMENT OF THE HOSE
IMPORTANT: Any maintenance operation shall be carried out by a suita-
bly trained staff, following carefully the information given in this manual.
Ensure that there is no tension in the spring before starting any opera-
tions inside the hose reel.
Always close the feeding of fluid to the machine before carrying out any maintenance on it.
Replace the flexible hose as soon as it shows any sign of wear and tear or of deterioration
due to the different conditions of the labour environment. We advise you to replace it every
year in case it is used for a few hours a week.
Replace the seal inside the revolving joint in case of losses due to wear and tear. Any repla-
cement of hose reel parts has to be done using original spare parts (see the spare parts list).
We advise you to contact the manufacturer for any possible anomaly and before replacing
any part. After every maintenance operation, put again the eventual supports.
GB
11.1
11.2
11.3
11.4
11.5
Replace the hose with another one of the same dimensions
and characteristics.
11.1) Remove the hose rubber stopper and release the hose
slowly until the spring is completely unloaded.
11.2) Loosen the swivel joint and remove the plastic cover.
11.3) After removing the plastic cover, loosen the screw
M8x50 and remove the spring likage shaft.
11.4) Grasp the end of the hose and pulling empty the drum.
11.5) Unscrew the internal fitting with the suitable wrench
and mount the new hose.
11.6) Assemble again the hose reel, by following the above
steps in reverse order. If that is the case, grease the
supports and the ratchet hook.
11.7) Go on as indicated at point 7.2 of the chapter: Mounting
of the hose.
WARNING! For safety reasons, operations of hose replacement
must be carried out at the bench.
Summary of Contents for BG
Page 38: ...38 NOTES...
Page 39: ...39 NOTES...
