5
MAN-AGY-005. Version 01 (01/11/2017)
If any of the Modbus communication parameters are dissimilar on the host unit or
remote keypad, communication will not be established. The keypad will display the
following screen:
By pressing the Right key, the user will be taken directly to the Modbus address
selection menu:
If the selected Modbus address is valid, the status screen is displayed:
Selecting Units To Monitor/Configure
When the Remote Keypad is attached to multiple agility
TM
units on the Modbus network,
the user can switch between each unit by using the following method.
(continued over)
Connection and Operation (continued)
Only Right key is active
May show: Local, Remote or Modbus
Press CENTRE key
Use UP / DOWN
keys to select
address.
Press centre to
confirm
To simplify this selection process it is recommended that the host agility
TM
units are
configured with consecutive Modbus addresses
