10
can be individually reset with a long key press. So the Micro Alti can store
your personal height record although you will probably want to reset max
and min lift. Minimum height can be used to check your lowest point
below take-off, to a maximum of -999 feet or -999 metres. Maximum
altitude is 19,999 feet and over 6000 metres.
Maximum LIFT is shown first followed by maximum altitude, then max
sink followed by minimum altitude.
Battery level is the final display on this button. A long key press gives
the actual battery voltage. The upper segments of the display will only
indicate while charging, after which a full charge is indicated with around
75% of the segments showing. i.e. around 4 volts. “batt” will flash
whenever the battery voltage drops to level “2” on the battery display.
Recharge the vario otherwise the time clock may need to be set again if
required, and to keep the battery in good condition. No other settings are
affected if the battery is allowed to run down completely and the battery
is protected from over-discharge.
Tip* The averager always appears first on the SET button menu. However
if, for example you are interested in regularly checking the temperature,
press the SET button until temperature is displayed and then press the
the ALTI button to return to the usual alti/vario display. Temperature will
now always appear straight after the averager when the SET button is
next used, so it will always be easy to find!
