1
Quick Guide
Switch the Micro Alti on by sliding the switch on the right side toward the top
corner. The Micro Alti will cycle through the display and bleep when it is ready.
Charge the Micro Alti via the USB socket if it doesn’t function.
This manual will begin with a brief introduction to each function and a full
description is given later in the manual. Time, altitude and other displays show
examples of typical readings.
To begin exploring the Micro Alti, press
each button and take a look at the menus.
The displayed functions can be adjusted by
pressing each button for about 2 seconds.
So, Short key presses are used to select the functions and and long key presses
affect the functions associated with each button.
Note that when the altimeter is displayed it won’t respond to very brief key presses,
this avoids inadvertent operation when you are flying.
Miscellaneous functions such as Averager, G-Meter, Temperature etc. are
accessed from the SET button and changes to how the Micro Alti responds;
Volume, Thresholds, Units etc. are accessed with a long initial press on the
SET button. To do this you may have to leave the SET menu by pressing ALTI
or TIMER, then press SET for 2 seconds. Most of the items on this menu can be
adjusted with the TIMER and ALTI buttons, this is shown in the manual and on
the Micro Alti as: v and
^
To finish, keep pressing the SET button to reach the end of the menu.
