59
B3.2 S
TANDARD
C
ONNECTIONS
- O
UTPUTS
NAME
DESCRIPTION
LOCATION
DESTINATION
SPEAKER 1A
Feed for Speaker 1
EDAC 8
Main Monitor amplifier L
SPEAKER 2A
Feed for Speaker 2
EDAC 8
Main Monitor amplifier R
SPEAKER 3
Feed for Speaker 3
EDAC 8
Main Monitor amplifier C
SPEAKER 4
Feed for Speaker 4
EDAC 8
Main Monitor amplifier Surround (LCRS
Mode)
Main Monitor amplifier Sub (5.1 Mode)
SPEAKER 5
Feed for Speaker 5
EDAC 8
Main Monitor amplifier Surround L
SPEAKER 6
Feed for Speaker 6
EDAC 8
Main Monitor amplifier Surround R
SPEAKER 7
Feed for Studio Speaker LEFT
EDAC 8
Studio Speaker or headphones amplifier
L
SPEAKER 8
As above, Studio Speaker
RIGHT
EDAC 8
Studio Speaker or headphones amplifier
R
Meter O/P 1
Meter feed from speaker path
1. NOTE signal is
UNBALANCED, -6dB.
EDAC 8
Customer supplied external meters.
These meters will meter whatever is
switched to the main monitors, and are
switchable PRE DOLBY, POST DOLBY,
POST MONO or POST Monitor Pot.
Meter O/P 2
As above, speaker 2
EDAC 8
As above
Meter O/P 3
As above, speaker 3
EDAC 8
As above
Meter O/P 4
As above, speaker 4
EDAC 8
As above
Meter O/P 5
As above, speaker 5
EDAC 8
As above
Meter O/P 6
As above, speaker 6
EDAC 8
As above
Meter O/P 7
as above, Studio Speaker L.
EDAC 8
As above, but will meter Studio speaker
selection
Meter O/P 8
As above, Studio Speaker R.
EDAC 8
As above.
The Monitor Schematic provides more detailed signal flow information.
The Monitor Box is controlled by Prodigy 2 via the X-Link cable, and must have its front
panel ID set to 2. This is achieved by inserting a thin pointer into the small hole on the front
panel and pressing the concealed switch there repeatedly until the numeral "2" is displayed
on the front panel indicator. The unit must be switched on to achieve this, and the setting is
remembered until a full reset or software download.
Audio connections are made via 4 x 56 way EDAC connectors, the Surround Monitor Rear
View diagram shows the relevant EDAC circuits. Refer to the diagrams for the relevant EDAC
pin outs.
Summary of Contents for Prodigy 2
