Fairlight SX-48, Service Manual

Service Manual 

C

HAPTER 

3

-

I

NSTALLATION 

P

ROCEDURE

July 24, 2008 

SX-48 Page 

11 

C h a p t e r   3   -   I n s ta l l a t i o n   P r o c e d u r e  

Installation Step-by-Step 

The following guide is Fairlight’s recommended step-by-step procedure for installation and 

commissioning the SX-48. 

Step 1 

Unpack 

Check the contents of the box, as outlined in the section “Contents of Box” above. 

Step 2 

Install Hardware 

See “Physical Installation” below. 

Step 3 

Factory Reset 

See “Factory Reset” below. 

Step 4 

Check LEDs for correct functioning 

See “Check I/O Hardware Indication” below. 

Step 5 

Set Sample Rate and Sync Source 

See “Sample Rate” and “Sync Source” below. 

Step 6 

Test with audio 

Physical Installation 

Environment 

The system is designed to be operated in a clean air-conditioned environment. Generally, an area 
comfortable for people (20°C - 21°C) should be suitable. The unit is intended for rack mounting, and 

it is recommended that support be given at the rear of the unit, as it is quite heavy. People installing 

the SX-48 should exercise caution in lifting it into place, as back injury can result from incorrect lifting 

technique. 

The SX-48 uses fans for ventilation.  Make sure that the rack unit has access for cool air to flow 
through the opening on the front of the SX-48 and warm air to be expelled from the back. There is no 

need to leave vertical spaces between SX-48 units in the rack, as long as the flow of air to and from 

the fans is good. 

As with all computer systems, the SX-48 will operate more reliably if static generating floor coverings 
are avoided. 

Do not fit the SX-48 into a closed environment except where ducted cool air is forced through the Unit. 
Do not run the unit whilst it is on or near the ground as it will accumulate dust, which may eventually 

cause a failure. 

Please Avoid: 

•

Fitting the SX-48 where air circulation will be restricted 

•

Installing close to a heat source 

•

Installing in dusty or damp area 

•

Installing in area subject to vibration 

•

Installing in area with strong magnetic or electric fields