User Manual
S
CREEN
M
IX
C
ONTROLS
February
16,
2010
Xynergi Media Production Centre
Page 190
Input Section
48 V and Mic Control
Used for Fairlight Mic preamps
Recording Section
Available only when a track is the current channel.
Arm means ready to record – press this button only if there is an audio source patched to the
current track.
Thru means the track will monitor its input, but will not respond to a record command. The Thru
state makes the track equivalent to a Live Feed. Press the Thru button only if there is an audio
source patched to the current track.
Rec Level controls the level going to the Disk before recording. It does not affect the track when
in Thru mode.
Trim controls the level as the channel enters the mixer. For tracks this is after coming back from
Disk, and does not affect level being recorded.
Phase flips the audio phase at the input to the mixer. It does not affect the signal being recorded
on a track.
Direct Send and Insert
Direct In toggles the Direct Output on and off
Pre toggles the Direct Output pre and post the main channel fader
Level controls the level going from the channel to the Direct Output
Note:
Direct outputs are only heard if patched to a physical output, or to the input of another
path. This is done in the Patch I/O screen (press the Patch I/O button).
Insert In controls the Insert Return only. When In, the channel listens to its Insert Return,
otherwise the Channel listens to the straight-through path. The Insert Send, on the other hand, is
always active (though it must be patched somewhere before it can be heard).
Note:
Insert sends and returns are only heard if patched to physical outputs / inputs, or to other
paths. Sends can be sent to the input of any path in the system, and returns can come from the
output or send of any path. This is done in the Patch I/O screen (press the Patch I/O button).
