User Manual
H
OW
T
O
… February
16,
2010
Xynergi Media Production Centre
Page 39
Step 1
Engage the Mute menu by either holding down the
Mute
button, or pressing the
SEL
button and then the
Mute Menu
button
Step 2
Select some channels to be muted.
Step 3
Hold down the
Mute Menu
button. Two new buttons appear beside it.
Step 4
Press the
to SEL
button. The SEL layout appears, and the channels that were muted are
now also selected. These channels are the ONLY channels selected – if there were other
channels selected before, they no longer are.
SEL to Solo or Mute
Constellation XCS allows you to solo or mute your selected channels. This is useful for listening
purposes.
To solo your selected channels:
Step 1
Engage the SEL layout by pressing the
SEL
button.
Step 2
Select some channels.
Step 3
Hold down the
SEL
button. Two new buttons appear beside it.
Step 4
Press the
to Solo
button. The SEL layout remains, but the selected channels are now
soloed. These channels are the ONLY channels soloed – if there were other channels
soloed before, they no longer are.
To mute your selected channels is the same procedure, but press
to Mute
in Step 4.
Solo Modes
Individual feeds may be soloed into the monitoring system. There are three solo modes which
may be entered by pressing the
SOLO
key above any fader. These are solo-in-place or SIP, after-
fader-listen or AFL, and pre-fader-listen or PFL.
SIP mutes all other feeds leaving only the soloed feeds feeding the bus being monitored. SIP
supports monitoring in any format.
AFL and PFL modes replace the current monitor source with a stereo solo bus whenever a feed is
soloed. All soloed feeds are routed to the solo bus. Soloed link groups are automatically
