User Manual
H
OW
T
O
… February
16,
2010
Xynergi Media Production Centre
Page 48
Use the
From
and
To
keys to make a range that represents the length of the Tape you want to
make.
Arm the tracks where you want to put a Tape Mode clip.
Press the
Setup Tape
soft key. Now you have two choices.
Blank Tape
will make a blank (zero waveform) Tape Mode clip on each armed track, filling the
range.
Render Tape
will make a single Tape Mode clip on each armed track, copying all the audio that is
already in the range on the armed tracks. Afterwards you can replace any parts that are not
correct by recording over them.
Both
Blank Tape
and
Render Tape
run quite fast – about 10 seconds for each hour of track
time. The advantage of using them is that you do not need to record sequentially – you can move
around anywhere in the Tape and replace the parts you are ready to work on.
Add Handle
Overview
A Handle is an extra piece of audio at the beginning of a recording. The system automatically
adds this piece, just as if you entered recording earlier.
This can be very useful when trying to capture performances, as it gives you extra time to react.
This guide shows you how to set the length of recording handles.
Get Ready
Press the green
Record
Megamode
button to access recording functions. The Arm menu will be
automatically selected.
Handle soft key
Press the Handle soft key, then change the displayed number of
frames
by typing on the
Numeric
Keypad
, using the
Jog
Wheel
, or pressing the
+
and
–
buttons.
Press
ENTER
to apply the displayed number.
Note:
if the transport has not been rolling for as long as the handle before you issue the record
command, the system will create a shorter handle.
Auto Name
Overview
Every clip is given an automatic name when you record it. This name consists of a
seedname
and
a
number
.
The seedname is applied first, then a number is appended, incrementing by one for each new clip.
Each Track has its own seedname.
You can change the seedname for each track, and also set the starting number at any time.
Get Ready
Press the green
Record
Megamode
button to access recording functions. The Arm menu will be
automatically selected.
