Baseball
74
MP-70/50
• MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13
1. Select the inning as instructed above.
2. Press
HOME SCORE BY INN
or
VISITOR SCORE BY INN
.
3. Press one of the following keys to adjust the score by the increment
indicated:
+1
,
+2
,
+3
or
-1
.
Or
1. Select the inning as instructed above.
2. Press
HOME SCORE BY INN
or
VISITOR SCORE BY INN
.
3. On the numeric keypad, enter the new score and then press
ENTER
.
If the automatic runs totaling feature is active, up to 19 runs per inning can be
displayed. If more than nine runs come across in any inning, the display window
for that particular inning
will flash the number “1” for one second out of every 11
seconds for the remainder of the game to indicate more than 10 runs. For
example, if there were 13 runs in the fifth inning, that window would display “3”
for 10 seconds, “1” for one second, “3” for 10 seconds and so on.
B
ALLS
,
STRIKES
,
AND OUTS
allows you to increase the ball, strike and out values with a single press of the
corresponding key. If this feature is not active, press
+1
or
-1
after
pressing
BALL
,
STRIKE
or
OUT
.
T
RACKING PITCH COUNT
Note: Pitch count feature is available only for board types 31 and 32 with
firmware version starting at 2.19 and board type 34 with firmware version
starting at 2.20.
This feature keeps track of the number of pitches by the home or visitor pitcher.
Perform the following after each pitch:
1. Press
HOME PITCH COUNT
or
VISITOR PITCH COUNT
button.
2. Press
+1
button. The total number of pitches for home or visitor will
then be updated and displayed on the corresponding 2-digit display of
the scoreboard.
C
LEAR PITCH COUNT
To clear the pitch count when there is a pitcher change,
