MP-73/53 G3 Wireless Option
MP-70/50
• MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13
127
R
ESET TO
F
ACTORY
G3
S
ETTINGS
1. Turn on the MP-73/53.
2. Press
SHIFT
+
BAT/RF
buttons and hold down for at least 6
seconds and release when it displays
ENTER PASS CODE
.
3. Type the following
sequence
3
2
1
4
ENTER
. It displays
Defaults Entered
to confirm that the control
has been reset to factory default settings.
G
ENERAL
G3
WIRELESS OPERATING GUIDELINES
Maintain a clear, unobstructed line-of-sight between the control antenna
and the receiving units.
Refer to
on page 120 for more
information).
If more than one control and scoreboard is in use at a facility and if they
are to operate independently, then set each control and scoreboard
combination to their own dedicated
group number
.
Warning: Avoid setting more than one control at a time to the
same group number as this will cause the scoreboard(s)
to malfunction.
Note: Trans-Lux Fair-Play can arrange a recommended radio frequency
group/channel plan for your site. Contact your sales representative for a
group/channel plan.
VOIDING POTENTIAL PROBLEMS WITH MULTIPLE
The scoreboard or shot timer lamp driver circuit card can accommodate
either conventional control wire hookup or wireless radio receiver and
can accept both data transmission methods simultaneously.
ENTER PASS CODE:
____________3214
