Programming the System Settings
MP-70/50
• MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13
145
S
ETTINGS FOR BASEBALL BOARD TYPES
34,
35
&
39
To display pitch speed on your scoreboard, you will need a Jug’s Speed gun
(model HTRCR-1K) and
a Jug’s cable (model R7010) or a Stalker Pro II Speed
Sensor. Your MP-70 control will also need to be enabled for this feature. This is
done at the factory. Consult your Fair-Play dealer for details.
Press
YES
if you want to enable pitch speed.
Press
NO
if you do not want to enable pitch
speed.
S
ETTINGS FOR BASEBALL BOARD TYPES
34
&
35
If you answered
YES
to PITCH SPEED prompt, then this will trigger the 2
DIGIT CLK prompt.
Press
YES
if you want to enable 2 Digit
Clock.
Press
NO
if you do not want to enable 2 Digit
Clock.
MP-70
AND
MP-69
DATA OUTPUTS
Your Fair-Play scoreboard requires data in one of two
formats: MP-70 or MP-69.
MP-69 is a data format developed in 1984, and still in use in some
incandescent-light scoreboards.
MP-70 is the current data format and was
developed in 1998.
Note: The tables listed under
on page 147 indicate which data format your
scoreboard model requires.
Note: Although Trans-Lux sells an MP-70 control, it is important to note that in
this instance, “MP-70” also refers to a protocol used by your controller to
communicate with the scoreboard. Hence, the MP-30 control uses the
MP-69 or the MP-70 data transmission method to communicate with your
scoreboard.
SYSTEM SETTINGS
PITCH SPEED? Y/N
SYSTEM SETTINGS
2 DIGIT CLK? Y/N
SYSTEM SETTINGS
CONN3&4,MP69?Y/N
SYSTEM SETTINGS
CONN.2,MP69? Y/N
SYSTEM SETTINGS
CONN.1,MP69? Y/N
