Soccer
MP-70/50
• MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13
55
SOCCER
If soccer is not the sport currently selected on the MP-70/50, or if you want to
change the controller
’s settings for soccer, see
S
ELECTING AND CHANGING SPORTS
on page 151.
You should also verify that the controller has been programmed to use the
correct scoreboard type and data format as instructed in
P
ROGRAMMING THE
S
YSTEM
S
ETTINGS
on page 142.
S
PORT
-
SPECIFIC
S
ETTINGS FOR
S
OCCER
When you select soccer, the MP-70/50 offers the sport-specific settings
discussed below. When you adjust these settings the MP-70/50 stores your
selections in permanent memory. Your settings become active each time you
select soccer in the future.
The sequence shown on the following pages presents you with all of the
options you could encounter while programming sports-specific settings.
However, these options presented to you may vary, depending upon the
type of your control (MP-70 or MP-50), the version number of the
firmware in your control, the two-
digit board type that you’ve selected, or
your scoreboard model. Hence, not all of the options outlined in this
chapter may appear on your control.
As you run through the following programming sequence, and you find
the need to back up to a previous programming option earlier in the
sequence, you can back up by selecting
SHIFT
+
8
.
You may skip a prompt by pressing the
NEXT
key. This will advance
you to the next prompt, but will save the existing settings of your current
prompt without making any changes. However, Fair-Play advises that
you respond
YES
or
NO
to all prompts, so that you have made all of
the appropriate selections for your sports event.
You may exit the programming sequence at any time by pressing
the
ESC
key. This will take you to the Quit prompt.
