FTP9000 Series Programmable DC Power Supply Operation Manual
____________________________________________________________________________
- 46 -
4.3.2 LAN
The FTP9000 series power supply has an Ethernet communication interface and adopts UDP communication
mode. The default IP address is 192.168.1.123, the default subnet mask is 255.255.255.0, and the default port
number is 7000.
----------------------------------------------------------------------------------------------------------------------
Before starting communication, make sure that the address of the PC and the power supply are
in the same network segment, and that there is no duplicate IP address with the power supply
in this network segment, otherwise it will not be able to connect correctly.
----------------------------------------------------------------------------------------------------------------------
4.3.3 CAN
The CAN interface uses a fixed communication speed of 500kbps, and the communication address can be set
from 0 to 255.
----------------------------------------------------------------------------------------------------------------------
CAN interface uses CANopen protocol.
----------------------------------------------------------------------------------------------------------------------
4.3.4 RS485
The RS485 communication interface configuration is the same as that of the USB serial port. The baud rate and
parity method can be configured through "Figure 4-1 Communication Parameter Setting Interface". The
connection method is as follows:
Summary of Contents for FTP9000 Series
Page 2: ......
