background image

FIG. 2

FIG. 1

Digital Angle Setter and Level

FAI RLANGLE

  

Please read and retain for future reference.

INSTRUCTION MANUAL

1

3

W

 Product Features

1. Fold-out angle leg      

 10. End cap/battery cover 

2. Joint cover                       

 11. Milled contact edge 

3. Base leg                          

 

DISPLAY ELEMENTS

4. 

ON/OFF

 button                    a. Reading 

5. 

MITER

 button                      b. Low battery (

LOWBAT

) indicator

6. 

HOLD

 button                       c. Mitre (

MTR

) indicator

7. LCD Display                         d. Hold (

HOLD

) indicator

8. Spirit level for horizontal plane
9. Spirit Level for vertical plane

 Preparation

INSERTING/REPLACING THE BATTERY (FIG. 2)

The digital Angle Setter is not supplied with a battery and one must 
be fitted before first use. Only use 9V PP3 batteries or one of the 
following equivalents MN1604, 6F22, 6LR61, 0068 or A1604. 

To open the end cap/battery cover (10) undo and remove the two 
end cap retaining screws and pull the end cap out. Insert the 
battery in to its compartment and connect the terminal lead. Press 
the 

ON/OFF

 button and check that the LCD screen is functioning.  

Push the battery fully in to its compartment and refit the end cap. 
Your Angle Setter is now ready for use. 

● When the ‘

LOW BAT

’ battery indicator (b) appears in the display 

   for the first time, measurements are still possible but accuracy 
   may be reduced, please replace the battery as soon as possible 
   to avoid any costly errors. 

● If the Angle Setter is not to be used for a prolonged period of 

   time the battery should be removed, as it may discharge and 
   corrode causing damage to the internal components. 

                                         

                                   

SWITCHING ON AND OFF

Press the 

ON/OFF

 button (4) to turn the Angle Setter on or off. 

After approximately 5 minutes without a button activation or an 
angle change, the Angle Setter will automatically shut itself off to 
preserve battery life.

 Operation Instructions

MEASURING ANGLES (FIG. 3)

Position the fold-out leg (1) and the base leg (3) planes against the 
edges to be measured. The displayed reading corresponds with 

the internal angle (W) between the base leg and the fold-out leg.

The reading is indicated on the LCD display until the legs are 
moved in relation to each other.  

Reviews: