32
EN
Manual Mode
1. Fill the water tank to the maximum line.
2. Place the stainless steel filter and the paper filter (V60) on the coffee carafe.
3. Place the Carafe into the appliance and turn the control knob to A/M mode. The ’’A/M”
LED light around the control button will light up.
4. Use the navigation buttons “ / ” to select MANUAL mode.
5. Press the Tare ( Weight) button and reset the display.
6. Put the desired amount of coffee on the paper filter.
7.Turn the control knob to “Temp” and the “Temp” LED around the control button will light up.
Adjust the desired temperature using the “ / ” navigation buttons.
8. Turn the control knob to C/W and the “C/W Ratio” LED around the control knob will light
up. Adjust the desired coffee / water ratio using the “ / ” navigation buttons.
9.After making all the desired settings, press the on/off button and start the appliance.
7. The display will first show the temperature of the water and the heating process will come
to an end when it reaches to the adjusted temperature.
8. When the heating process is finished, the water will begin to flow into the carafe and the
amount of water flowing will be seen as ml on the display.
9.After the process is completed, put the filter on the filter stand and you can serve the
coffee.
NOTE !
The water temperature can only be adjusted between 80 °C and 98 °C in the Manual
setting.
The coffee/water ratio (C/W Ratio) can be set between 1:10 and 1:20.
Programming Mode / Delayed Start
You can use the Program Mode to set up your appliance and make your coffee ready at any
time you want.
1. Set the appliance to A/M mode.
2. Select either AUTO or MANUAL mode using the navigation buttons.
3. If manual mode is selected, adjust the water temperature and C/W setting.
4. Turn the control knob to Program. ‘’Program’’ LED light will light up around the control
knob and ‘’0:00’’ will appear on the display. The time and minute you set on this display
is not the time that you set for the appliance but it is the time to program your coffee for
brewing.
5. Use the up and down “ / ” navigation buttons to set the time. Press the on-off button
to approve.
6. The minutes section will start flashing after the clock is set. Again, Use the up and down “
/ ” navigation buttons to set and press the control button to approve.
7. After the clock is set, press the on/off button again and “PROG” letters will appear on the
display. This will allow you to set up the device for a delayed start.
8. When you reach the adjusted time, the device will start and your coffee will start brewing.
Summary of Contents for AROMA MASTER
Page 2: ...Deutsch 3 English 21 Türkçe 37 Русский 53 العربية 71 ...
Page 85: ...NOT NOTES ...
Page 86: ...NOT NOTES ...
Page 87: ...NOT NOTES ...
